COPYRIGHT 2009 ENTONE, INC. ALL RIGHTS RESERVED
.
Amulet Quick Reference Guide (NTSC)
1. Welcome!
Thank you for using Entone's Amulet High Definition IP Television Receiver. This quick reference gives
quick instruction for setting up and using Amulet. For detailed setup and usage instruction, please refer
to the Amulet User's Guide and the URC Plus User's Guide in http://www.entone.com.
2. Before You Begin
Check that the video output connector of the Amulet is properly connected to the input connector of the
TV(s).
In your TV, select the input source that the Amulet is used.
Use the "CH3/CH4" switch at the rear panel of the Amulet to select either channel 3 or channel 4 for the
"COAX" RF TV output.
Check that you have connected Amulet "ETHERNET" to your network access device. For details of
connecting Amulet to the network, please refer to your service provider.
Software upgrade is required when you power up Amulet for the first time. Software upgrade may take 5-
10 minutes. Do not power off during software upgrade.
3. Install Remote Control Batteries
Install the two AA batteries (provided) into the remote control.
Important!! Use only new AA Alkaline batteries to insure consistent operation.
4. Understanding the Remote Control
This 3 mode Universal Remote Control can be programmed to control your Amulet and up to two other
devices.
Amulet uses InfraRed (IR) to receive remote control signals. IR signals travel only short distances (40
feet or less), and cannot go through walls or other solid objects. You must point the remote control to the
Amulet, with no objects blocking the line of sight.
Amulet Quick Reference (P/N 95-80xxxx-06)
1
v1.3