Weslo Vector 303 Bike Manual page 10

3. Slide the two slots in the Handlebar Clamp (42) onto the
two indicated tabs on the Upright (13). Lift the bottom of
the Handlebar Clamp away from the Upright, and insert
the Handlebar (15) between the Handlebar Clamp and
the Upright. Centre the Handlebar and rotate it to the
desired position.
Insert the Adjustment Handle (36) into the Handlebar
Clamp (42) and tighten the Adjustment Handle into the
Upright (13). Note: The Adjustment Handle works like a
spanner. Turn the Handle clockwise, pull it away from
the Upright, turn it counterclockwise, push it toward the
upright, and then turn it clockwise again.
4. The Console (16) requires three "AA" batteries; alka-
line batteries are recommended. Insert three batteries
into the Console. Make sure that the batteries are
oriented as shown by the diagram inside the
Console.
5. Hold the Console (16) near the Upright (13). Insert the
console cable and the console wire into the indicated
hole and down through the Upright. Attach the earth
wire to the Upright with the Earth Screw (27).
Insert the excess cable and wire into the Upright (13).
Attach the Console (16) to the Upright with four M5 x
12mm Screws (49). Be careful to avoid pinching the
wires.
3
13
4
16
5
Earth
Wire
27
49
Hole
49
5
15
Tabs
42
36
Batteries
16
Console
Wire
Console
Cable
13
Be careful to
avoid pinching
the wires.