To Operate Your Tv/Vcr Combination - Radio Shack 4-IN-1 REMOTE CONTROL Owner's Manual

15-1991.fm Page 7 Wednesday, October 20, 1999 10:37 AM
Note: If the code you entered is invalid,
the red light blinks.
4. Point the remote control at your device and
press . Your device should turn off
POWER
(or on, if it was off).
If the remote does not operate your device,
try the other codes listed in "Manufacturer
Codes" on Page 14 for your brand of TV,
VCR, cable converter, or CD player.
5. Repeat Steps 2–4 for additional devices.
TO OPERATE YOUR TV/VCR
COMBINATION
1. Locate the codes for your TV/VCR combi-
nation in "TV/VCR Combinations" on
Page 33 and write them on the 4-in-One's
label.
2. Press . The red light blinks.
VCR
3. Hold down until the red light blinks twice,
P
then enter the 4-digit manufacturer's code.
When the red light blinks twice again, the
remote control has accepted the code.
Note: If the code you entered is invalid,
the red light blinks.
4. Point the remote control at your TV/VCR
combination and press
device should turn off (or on, if it was off).
If the remote does not operate your device,
try the other codes listed for your TV/VCR
combination.
Note: Some TV/VCR combinations require
a second code to control volume. If you
cannot get the volume to work, use the TV
code listed in "TV/VCR Combinations" on
Page 33.
. Your
POWER
7