JVC KD-AVX77 Installation & Connection Manual page 4

B
Connecting the external amplifiers
You can connect amplifiers to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.
• For amplifier only:
– After you have connected the center speaker, make sure to activate the center speaker; otherwise, no sound comes out of the connected center speaker, see page 17 of the INSTRUCTIONS.
– Disconnect the speakers from this unit, and connect them to the amplifier. Leave the speaker leads of this unit unused.
– You can switch off the built-in amplifier and send the audio signals only to the external amplifier(s) to get clear sounds and to prevent internal heat buildup. See page 24 of the INSTRUCTIONS.
Rear speakers
JVC Amplifier
Front speakers
C
Connections for external component playback
KS-HP2
Cordless headphones (not supplied)
2nd monitor
(KV-MR9010, etc.)
Normally connect an NTSC monitor. When you watch
the video on iPod or external component, connect a
monitor compatible with both NTSC and PAL.
s
D
Connecting external components
When connecting the external components, refer also to the manuals supplied for the components
and adapters.
CAUTION:
Before connecting the external components, make sure that the unit is turned off.
You can connect the following JVC components to the CD changer jack.
JVC Component
CD changer (CD-CH)
JVC DAB tuner
You can also connect the following components through the various JVC adapters.
• Connection cords may need to be purchased separately.
Component
iPod
Portable audio player with line output jacks
Portable audio player with 3.5 mm stereo mini jack
When connecting two components, it is recommended that you connect them in series as explained
below.
KD-AVX77/KD-AVX55
CD changer jack
* 10 To use these components, set the external input setting correctly (see page 19 of the INSTRUCTIONS).
To disconnect the connector
Remote lead
Remote lead (Blue with white stripe)
Front speakers
JVC Amplifier
Video cord (not supplied)
9
*
KV-CM1
Rear view camera (not supplied)
Model name
CH-X1500 etc.
KT-DB1000
Adapter
Interface adapter for iPod
Line input adapter
AUX input adapter
A
KT-DB1000
B * 10
CD-CH / KS-PD100 / KS-U57 / KS-U58
Hold the connector top tightly (1),
then pull it out (2).
* 7
Audio cord (not supplied)
* 8
Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint
(if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.
Camcorder, Navigation
System, etc.
Audio/video cords (not supplied)
USB devices
USB cable—approx.1.2 m
Model name
You cannot connect a computer to the USB (
KS-PD100
KS-U57
Connecting the iPod or iPhone device to the USB terminal
KS-U58
You can connect the iPod or the iPhone to the USB terminal using the following cables:
– To listen to the music: USB 2.0 cable (accessory of the iPod/iPhone)
– To watch the video: USB Audio and Video cable for iPod/iPhone—KS-U30 (not supplied)*
11
* When using the cable, make sure <iPod(Off)> is selected for <AV Input> (see page 19 of the
INSTRUCTIONS).
• iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
• iPhone is a trademark of Apple Inc.
4
Y-connector (not supplied for this unit)
To the remote lead of other equipment or power antenna if any
JVC Amplifier
Subwoofer
JVC Amplifier
Center speaker
9
* To listen to disc playback sound while in Dual Zone
operations (see page 43 of the INSTRUCTIONS).
USB device
) terminal of the unit.
KS-U30
USB 2.0 cable
11
iPod/iPhone
iPod/iPhone