Table of Contents
Advertisement
INTRODUCTION
Thank you for purchasing this Guardian model by Generac
Power Systems Inc.. This model is a compact, high per-
formance, air-cooled, engine-driven generator designed to
automatically supply electrical power to operate critical
loads during a utility power failure.
This unit is factory installed in an all-weather, metal enclosure
that is intended exclusively for outdoor installation. This gen-
erator will operate using either vapor withdrawn liquid propane
(LP) or natural gas (NG).
This unit meets the 1998 and later California emissions
regulations. To ensure that the engine continues to meet
these regulations, refer to the following information and
instructions in this owner's manual.
ENGINE EMISSION COMPLIANCE PERIOD
For nonhandheld engines: The Emissions Compliance
Period referred to on the Emissions Compliance label indi-
cates the number of operating hours for which the engine
has been shown to meet federal emission requirements.
For engines less than 225 cc displacement, Category C =
125 hours, B = 250 hours, and A = 500 hours.
For engines 225 cc or more, Category C = 250 hours, B =
500 hours, and A = 1000 hours.
READ THIS MANUAL THOROUGHLY
If any portion of this manual is not understood, contact the
nearest Authorized Dealer for starting, operating and servic-
ing procedures.
Throughout this publication, and on tags and decals affixed
to the generator, DANGER, WARNING, CAUTION and
NOTE blocks are used to alert personnel to special instruc-
tions about a particular operation that may be hazardous if
performed incorrectly or carelessly. Observe them carefully.
Their definitions are as follows:
DANGER
After this heading, read instructions that, if not
strictly complied with, will result in serious person-
al injury, including death, in addition to property
damage.
After this heading, read instructions that, if not
strictly complied with, may result in serious person-
al injury or property damage.
After this heading, read instructions that, if not
strictly complied with, could result in damage to
equipment and/or property.
After this heading, read explanatory statements
that require special emphasis.
These safety warnings cannot eliminate the hazards that
they indicate. Common sense and strict compliance with the
special instructions while performing the service are essen-
tial to preventing accidents.
Four commonly used safety symbols accompany the
DANGER, WARNING and CAUTION blocks. The type of
information each indicates follows:
NOTE:
This symbol points out important safety informa-
tion that, if not followed, could endanger personal
safety and/or property of others.
This symbol points out potential explosion hazard.
This symbol points out potential fire hazard.
This symbol points out potential electrical shock
hazard.
The operator is responsible for proper and safe use of
the equipment. We strongly recommend that the operator
read this Owner's Manual and thoroughly understand all
instructions before using this equipment. We also strongly
recommend instructing other users to properly start and
operate the unit. This prepares them if they need to operate
the equipment in an emergency.
CONTENTS
This manual contains pertinent owner's information,
including warranty, electrical diagrams, exploded views
and lists of repair parts, for three different models:
• 04758-2 – 6 kW NG, 7 kW LP , single-cylinder GH-410
Engine
• 04759-2 – 12 kW NG, 12 kW LP , V-twin GT-990 Engine
• 04760-2 – 13 kW NG, 15 kW LP , V-twin GT-990 Engine
OPERATION AND MAINTENANCE
It is the operator's responsibility to perform all safety
checks, to make sure that all maintenance for safe operation
is performed promptly, and to have the equipment checked
periodically by an Authorized Dealer. Normal maintenance
service and replacement of parts are the responsibility of the
owner/operator and, as such, are not considered defects in
materials or workmanship within the terms of the warranty.
Individual operating habits and usage contribute to the need
for maintenance service.
Proper maintenance and care of the generator ensures a
minimum number of problems and keep operating expens-
es at a minimum. See the Authorized Dealer for service
aids and accessories.
HOW TO OBTAIN SERVICE
When the generator requires servicing or repairs, simply
contact an Authorized Dealer for assistance. Service tech-
nicians are factory-trained and are capable of handling all
service needs.
When contacting an Authorized Dealer about parts and
service, always supply the complete model number and
serial number of the unit as given on its data decal, which is
located on the generator.
Model No. ____________ Serial No. ______________
AUTHORIZED DEALER LOCATION
To locate the nearest AUTHORIZED
DEALER , please call this number:
1-800-333-1322
or locate us on the web at
www.generac.com
Hide quick links:
Advertisement
Table of Contents
