B&B Electronics, Inc.
4.3
Power Connector
.
2-PIN PANEL SOCKET
Pin
Signal
number
mark
1
VCC (+)
2
GND (-)
The router requires a +10 V to +30 V DC supply. Protection against reversed polarity is built
into the router.
The power consumption during receiving is 1W. The peak power consumption during data
sending is 5.5W. For correct operation, the power source must be able to supply a peak
current of 600mA.
The power cable connects to the router via locking screws. (See Fig. 8)
Circuit example:
The positive VCC input is marked by a red socket on the power
Positive input of DC supply voltage (+10 to +30 VDC)
Negative input of DC supply voltage
Table 9: Connection of power connector
Fig. 7: Power connector
Fig. 8: Connection of power supply connector
Fig. 9: Connection of power supply
Description
.
18
SPECTRE User Manual
SPECTRE_User_Manual_2912m
www.bb-elec.com
www.bb-europe.com