X10 MT12 User Manual page 10

You still can control modules instantly with the MODE switch in the
CLOCK SET position. Remember to set the MODE switch back to
the RUN position and WAKE switch back to ON to resume the
alarm setting.
Programming a timed event
Set the MODE switch to the PROG. SET/REVIEW position.
Set the Module SELECTOR switch to 1-4 or 5-8.
Advance the TIME + key to the desired time. Hold it down to
reach the desired time faster. If you go too far, press - to go
back.
Press ON or OFF for the Unit Code for which you want to
program a time.
Set the MODE switch back to RUN.
For example: If you set your programmed time to 14:45, and then
press the ON button for module 2, you will program the module set
to Unit Code 2 to turn on at 14:45 everyday. If you set your
programmed time to 7:00, and then press the OFF button for module
2, you will program the module set to Unit Code 2 to turn off at 7:00
everyday.
You can program a total of 64 On or Off times. These are
distributed between the eight Unit Codes (selected with the four
ON/OFF buttons). If you try to set a programmed time, and the
memory is full, the display will read FULL. To remove this, press the
CLEAR button.
If FULL is displayed when you try to enter a programmed time, you
have already used up all the available memory. Cancel one or more
of your set times by pressing a number ON or OFF button, and
press CLEAR to clear that event. Program another time for the
selected module.
Setting a timed event to occur once
To program your timed event to occur only once, repeatedly press
the MODE button until ONCE shows in the display.
BMB HOME 10 rev. 01-10-05