3-2.5 Cmos Clearing (Jp5); 3-2.6 Power On - SOYO LI-7000 User Manual

Motherboard's Hardware Installation
Make sure to set the AC line input appropriately based on
the local electricity supply. Improper setting may cause the
damage of the power supply or system.

3-2.5 CMOS Clearing (JP5)

After you have turned off your computer, clear the CMOS memory by
momentarily shorting pins 2-3 on jumper JP5, for a few seconds. Then
restore JP5 to the initial 1-2 jumper setting in order to recover and retain
the default settings.
Jumper JP5 can be easily identified by its white colored cap.
CMOS
Clearing
Short pin 2-3 for
at least 5 seconds to
JP5 Setting
clear the CMOS
Note: You must unplug the ATX power cable from the ATX power
connector when performing the CMOS Clear operation.

3-2.6 Power On

You have now completed the hardware installation of your Motherboard
successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the system
is performing the diagnostic checks.
Note: If you have failed to enter the BIOS, wait until the boot up
sequence is completed. Then push the RESET button and press
<DEL> key again at the beginning of boot-up, during diagnostic
checks.
Clear CMOS Data
43
Retain CMOS Data
Short pin 1-2
to retain new
settings
1 2 3
LI-7000
1 2 3