Multitech MultiModem II MT5600BA-V92 User Manual page 22

COMMAND MODE The following LCDs are used to configure result code responses.
OPTIONS
ENABLE/DISABLE
RESPONSE
VERBOSE/TERSE RESPONSE
ENABLE/DISABLE CMD
MODE
Use  and Enter to select the method of data transmission.
SYNC/ASYNC
OPTIONS ASYNC, NORM?
ASYNC, V.25bis?
SYNC, NORM?
SYNC /External Clock
SYNC Slave
V.25bis BISYNC?
Use  and Enter to reset Profile 0 and the modem's active configuration to the
RESET FACTORY
DEFAULTS factory defaults. Same as the AT&F&W command string.
Use  and Enter to change the modem's serial port and data transmission
CONNECT RATE
OPTIONS speeds.
SERIAL BAUD RATE
MODEM SPEED
Multi-Tech Systems, Inc. MT5600BA-V92 User Guide
Use  and Enter to enable or disable the sending
of result codes to the computer. Same as the Q0
and Q1 commands.
Use  and Enter to select verbose or terse result
codes. Same as the V0 and V1 commands.
Use  and Enter to enable or disable the modem's
ability to accept AT commands.
Normal asynchronous transmission using the AT
command set.
Asynchronous transmission using the V.25bis
command set.
Normal synchronous transmission using any
command set.
V.25bis bisynchronous transmission.
Use  and Enter to select the modem's serial port
speed. The valid range is 1200 to 115200 bps. Same
as the $SB commands.
Use  and Enter to select the modulation protocol
to use in originating or answering a connection. This
also selects the maximum transmission speed at
which the modem can operate. Same as the
+MS=[mod] command.
Chapter 3 – Using the Front Panel
22