Specifications - Peavey TriFlex II Operating Manual

TRIFLEX II SYSTEM SPECIFICATIONS
™
SUBWOOFER
Transducer complement: 1 x 15" woofer,
custom heavy-duty
Nominal Impedance: 8 ohms
Power Handling, Transducer: 350W
Continuous, 700W Program
Box tuning frequency (Fbox): 48 Hz
Frequency Response, 1 meter on-axis,
swept-sine in anechoic environment (thru
system electronics): 40 Hz to 105 Hz
Usable low frequency limit (-10 dB point):
34 Hz
Sound Pressure Level, 1 Watt, 1 meter in 1
/ 2 space environment: 102 dB
Maximum Sound Pressure Level (1 meter,
1 / 2 space): 127 dB
Weight: 98 lbs. (44.5 kg)
Dimensions (H x W x D): 19.65" X 28.00"
X 28.10" (Includes feet)
(unit down on feet)
19.65" X 32.00" X 28.10" (Includes feet
and casters)
Height in Transport mode: 32.00"
SATELLITE SPEAKERS
Transducer complement:
Low Frequency Section: 1 x 10" woofer,
custom heavy-duty
High Frequency Section: 1 x 1.4" titanium
compression driver on a Quadratic Throat
Waveguide with 75 degrees by 75
™
degrees coverage pattern
Nominal Impedance: 4 ohms
Power Handling, Satellite System: 200W
Continuous, 400W Program, 800W Peak
Box tuning frequency (Fbox): 84 Hz
Frequency Response, 1 meter on-axis,
swept-sine in anechoic environment: 88
Hz to 20 kHz
Triflex II
™

SPECIFICATIONS

Sound Pressure Level, 1 Watt, 1 meter in 1
/ 2 space environment: 101 dB
Maximum Sound Pressure Level (1 meter,
1 / 2 space): 124 dB
Weight: 24 lbs. (10.9 kg)
Dimensions (H x W x D): 19.6" X 11.83" X
11.83" (Upright, Includes feet)
COMPLETE SYSTEM
Active Crossover Frequency: 120 Hz, 24
dB/Octave
Maximum Sound Pressure Level (1 meter,
half-space): 129 dB
Dimensions when in transport
orientation, on casters (H x W x D):
43.00" X 20.37" X 23.54" (Includes all
feet)
Weight (Sub and Satellites Only): 146 lbs.
(66.4 kg)
Speaker Cables: Two 15 foot 16 ga. with
4-pin twist-lock connectors on each end.
INTERNAL AMPLIFIER SPECIFICATIONS
Subwoofer Amp Power Output: 500W
peak available power 250W continuous,
into 8 ohms.
Satellite Amps Power Output: 250W peak
available power 125W continuous, into 4
ohms.
Inputs (Line Level): Left channel XLR or 1
/ 4" phone jack combo input (female)
Right channel XLR or 1 / 4" phone jack
combo input (female)
Input Impedance: 20 k Ohms balanced,
10 k Ohms unbalanced (single-ended)
Thru (Outputs, Line Level): Left channel
XLR full-range output (male)
Right channel XLR full-range output
(male)
Speaker Level Outputs:
Left channel 4-pin twist-lock professional
connector Output
23
Right channel 4-pin twist-lock
professional connector Output
CONTROLS:
Master System Level (Left & Right Gain)
Subwoofer Level Control
Ground Lift Switch
Power Switch (On rear of amp panel
when the Subwoofer is in use position,
with rubber feet on the floor)
Nominal amplifier frequency response:
+0, -2 dB from 10 Hz to 20 kHz
Hum and noise: Greater than 90 dB
below rated power
DDT dynamic range: Greater than 18 dB
THD: Typically less than 0.05 %
Infrasonic filter protection: 36 dB/octave
roll-off
Power Requirements: Domestic 120VAC,
60 Hz, 210 Watts