Peavey TriFlex II Operating Manual

Peavey TriFlex II Operating Manual

Three-way self-powered two-channel sound reinforcement system
Hide thumbs Also See for TriFlex II:

Advertisement

TriFlex
II
Three-way self-powered two-channel sound
reinforcement system
Operating
Manual
www.peavey.com

Advertisement

Table of Contents
loading

Summary of Contents for Peavey TriFlex II

  • Page 1 TriFlex ™ Three-way self-powered two-channel sound reinforcement system Operating Manual www.peavey.com...
  • Page 2 ATTENTION: Afin de réduire le risque de choc électrique, ne pas enlever le couvercle. Il ne se trouve à l’intérieur aucune pièce pouvant être reparée par l’utilisateur. Confiez I’entretien et la réparation de l’appareil à un réparateur Peavey agréé. AVIS: Dans le but de reduire les risques d’incendie ou de decharge electrique, cet appareil ne doit pas etre expose a la pluie ou a l’humidite et aucun objet rempli de liquide, tel qu’un vase, ne doit etre pose sur celui-ci.
  • Page 3: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electrical products, basic cautions should always be followed, including the following: Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with a dry cloth. Do not block any of the ventilation openings.
  • Page 4 Satellites to the TriFlex II System electronics in the Subwoofer cabinet. Any good quality 1 3/ 8” diameter pole speaker stands can be used with the TriFlex II Satellite speakers, and there is a specific model of speaker stand available as an accessory that will fit into the free slipcover supplied with the TriFlex II, the model PP1 speaker stand, Peavey...
  • Page 5 This receptacle is for the IEC line cord (supplied) that provides AC power to the unit. It is very important that you ensure the TriFlex II has the proper AC line voltage supplied. You can find the proper voltage for your TriFlex II printed next to the IEC line (power) cord on the rear panel of the unit.
  • Page 6 These male XLR jacks provide a means to send the input signal on to another device, or to daisy chain the TriFlex II into another TriFlex II unit. These can also be used to connect a TriFlex II system for mono input ™...
  • Page 7 TriFlex II not be placed in a closed space or a space that has no fresh, cool airflow. DO NOT connect the inputs of the TriFlex II to the output of a power amplifier. The inputs are meant to be driven from a line-level strength signal.
  • Page 8 The best option is a shielded balanced XLR cable no longer than necessary to reach the TriFlex II. It is usually a good idea to leave some slack at the input to the TriFlex II, and also to tape the cables down or run them under a cable guard to avoid anyone tripping over them or pulling the cable out of the TriFlex II system input.
  • Page 9 (one-half way up recommended to start). It is not good practice to turn the Master System Level control on the TriFlex II all the way up and then try to control level only from the mixer, this approach would tend to pick up excess noise. Best practice would be to run a “hot”...
  • Page 10 (5) on the TriFlex II has not been set too low. Check that the input plugs are fully seated in the input jacks (7) and (10) or the RCA jacks (14) on the rear panel of the TriFlex II. Ensure that a power amp has not been plugged into one of the input jacks of the TriFlex II.
  • Page 11 Never clean the TriFlex II while plugged in or turned ON! When the unit has been fully disconnected from AC power sources, use a dry cloth to remove soil or other dirt. Never use strong solvents on the TriFlex II, as they could damage the cabinet.
  • Page 12: Specifications

    Triflex ™ SPECIFICATIONS TRIFLEX II SYSTEM SPECIFICATIONS Sound Pressure Level, 1 Watt, 1 meter in 1 Right channel 4-pin twist-lock ™ / 2 space environment: 101 dB professional connector Output SUBWOOFER Maximum Sound Pressure Level (1 meter, CONTROLS: Transducer complement: 1 x 15” woofer, 1 / 2 space): 124 dB custom heavy-duty Master System Level (Left &...
  • Page 13 23.500 31.970 28.000 19.820 19.000 11.750 11.750 19.475 19.000...
  • Page 14 RCA Phono Cables Guitar XLR Cables CD Player/MP3 Player Mixer Inputs Outputs Dynamic Mic (No Electrets) Mixer Cables TriFlex II Input/Output Panel Inputs 4 Pin Twist- Lock To 4 Pin Twist-Lock Speaker Cables Mixer TriFlex II Satellite TriFlex II Satellite Speaker...
  • Page 15 Lock To 4 Pin Twist-Lock Speaker Cables TriFlex II Satellite TriFlex II Satellite Speaker Speaker DAISY CHAIN USE OF MULTIPLE TRIFLEX II SYSTEMS XLR Cables TriFlex II Input/Output Panel Inputs Outputs Mixer 4 Pin Twist- 4 Pin Twist- Lock To 4 Pin...
  • Page 18 Features and specifications subject to change without notice. Peavey Electronics Corporation • 5022 Hartley Peavey Drive • Meridian • MS • 39305 (601) 483-5365 • FAX (601) 486-1278 • www.peavey.com • ©2010 Printed in the U.S.A. EX000104...
  • Page 19 What Peavey Will Do We will repair or replace (at Peavey’s discretion) products covered by Warranty at no charge for labor or materials. If the product or component must be shipped to Peavey for Warranty service, the consumer must pay initial shipping charges. If the repairs are covered by Warranty, Peavey will pay the return shipping charges.
  • Page 20 U.S. customer warranty registration. Logo referenced in Directive 2002/96/EC Annex IV (OJ(L)37/38,13.02.03 and defined in EN 50419: 2005 The bar is the symbol for marking of new waste and is applied only to equipment manufactured after 13 August 2005...

Table of Contents