Philips Magic 3-2 User Manual page 37

Problems when faxing or printing
Faxes are of poor quality.
Your fax or your recipient's fax machine produces
black lines when printing.
Copy is blank.
Problems with the connection
Your fax machine rings once, then there is a mo-
ment of silence and another ring signal after that.
NO CONNECTION
or REDIAL FAILED
NO LOOP CURRENT
When you lift the receiver of your fax machine
you do not hear the dial tone. The display shows:
NO DIALTONE
BUSY
or
fax transmissions are constantly interrupted.
You cannot receive any faxes.
On lifting the handset you hear a tone or silence.
EXTERNAL PHONE
The red lamp v flashes.
Change the resolution setting to F or f.
Check the document or set a higher contrast with function
47 (see chapter Fax & Copy / Contrast).
Test the fax machine by making a copy. If your copy is fault-
less the correspondent's fax machine might be defective.
Call service if necessary.
Clean the scanner with a cloth (see Care).
Test the fax machine by making a copy. If your copy is fault-
less the correspondent's fax machine might be defective.
Call service if necessary.
Load the document with the printed side up.
Call service if necessary.
This is entirely normal. After the first ring signal the fax ma-
chine takes over the call. When the fax machine has recog-
nised that the incoming call is a telephone correspondence,
the fax machine will continue to ring.
Try later or draw your fax partner's attention to a possible
installation fault.
Check the installation of your fax machine.
Connect your telephone cable to the socket on the bottom
of your fax machine identified with LINE.
Try to send the fax manually: Press DIAL/z and dial the
fax number. If the recipient is using an automatic answer-
ing device, wait until you hear a tone after the pre-recorded
message. Press START.
Set the number of ringing signals for the answering machine
or the total number of ringing signals with function 31 or
32 to lower than five.
You are receiving a fax. At the fax machine: Press START.
At an additional telephone: press * and 5. Replace the
handset.
This is not a fault. You are now using an additional tele-
phone.
User Manual
37