Installation; Your Safety First - Amana MVH140E Owner's Manual & Installation Instructions

YOUR SAFETY FIRST

Read this entire manual before you begin.
Proper installation is the installer's responsibility!
° ‹
– Write the model & serial numbers on the owner's manual. The model number label is located on the oven
front. See Figure 1. The mounting plate is located on the back side of the microwave oven. See Figure 2.
BE SURE TO READ THE FOLLOWING SAFETY INSTRUCTIONS:
Model Number Label
The dimensions of the oven are as follows:
Height : 16 / inches
7 16
Width : 29 / inches
15 16
Depth : 15 / inches
3 8
Weight : 58 pounds
FOR YOUR SAFETY:
You will need TWO people to install this oven. It is heavy and could cause personal injury if not handled
° ‹
properly.
Avoid Electrical Shock!
° ‹
– Before you drill into the wall, note where electrical outlets are and where electrical wires might be concealed
behind the wall. YOU COULD GET AN ELECTRIC SHOCK if you contact electrical wires
with your drill bit.
– Locate and disconnect the power to any electrical circuits that could be affected by installing this oven.
IF YOU DO NOT DISCONNECT THE POWER, YOU COULD GET AN ELECTRIC SHOCK.
ELECTRICAL RATING OF THIS OVEN : 120V AC 60Hz.
° ‹
11.9 A / 1350 W (Microwave oven only)
12.9 A / 1460 W (Microwave oven + Cooktop Lamps + Ventilation Fan)
– You need a DEDICATED 120V, 60Hz, AC only, 15 or 20A, fused electrical supply (located in the cabinet
above the microwave as close as possible to the microwave) serving only the microwave.

INSTALLATION

BEFORE YOU START
Figure 1
W A R N I N G
- 29 -
Mounting
plate
( Remove from
oven to install. )
Back of oven
Figure 2