Operating this unit
Switching the ring tone
1
Display the function menu.
Refer to Introduction to advanced operations
on page 34.
2
Use MULTI-CONTROL to select
RING TONE in the function menu.
3
Push MULTI-CONTROL left or right to
select the desired setting.
OFF (off)—1—2—3
Making a call by entering
phone number
Important
Be sure to park your vehicle and apply the park-
ing brake when performing this operation.
1
Display the function menu.
Refer to Introduction to advanced operations
on page 34.
2
Use MULTI-CONTROL to select
NUMBER DIAL.
# You can also press DIRECT on the remote con-
trol to enter in this menu from the standby dis-
play.
3
Push MULTI-CONTROL up or down to
select a number.
# You can also perform the same operation by
pressing 0 to 9 on the remote control.
4
Push MULTI-CONTROL left or right to
move the cursor to the previous or next po-
sition.
# Up to 24 digits can be entered.
5
When you finish entering the number,
press MULTI-CONTROL.
Call confirmation appears.
# You can also perform the same operation by
pressing thumb pad on the remote control.
6
Press MULTI-CONTROL again to make a
call.
# You can also perform the same operation by
pressing
on the remote control.
7
To end the call, press
# You can also perform the same operation by
pressing
on the remote control.
Clearing memory
1
Display the function menu.
Refer to Introduction to advanced operations
on page 34.
2
Use MULTI-CONTROL to select
CLR MEMO.
3
Push MULTI-CONTROL up or down to
select an item.
PH BOOK (phone book)—ALL (delete all
memory)—PRESET (preset phone numbers)—
RECENT (call history)
# If you want to clear the entire Phone Book,
call history list and preset phone number, select
ALL.
4
Push MULTI-CONTROL right to deter-
mine the item that you want to delete
from this unit.
CLEAR MEMORY YES is displayed. Clearing
memory is now on standby.
# If you do not want to clear the memory that
you have selected, push MULTI-CONTROL left.
The display reverts to normal.
5
Press MULTI-CONTROL to clear the
memory.
CLEARED is displayed and data on the se-
lected item is cleared from this unit's memory.
Changing the phone book
display order
1
Display the function menu.
Refer to Introduction to advanced operations
on page 34.
2
Use MULTI-CONTROL to select
PH. B. NAME VIEW.
INVERT NAMES YES is displayed.
3
Press MULTI-CONTROL to change the
name view order.
INVERTED is displayed.
Section
02
.
37
En