Table of Contents
Advertisement
Section
04
Initial Settings
1
Display the initial setting menu.
Refer to Adjusting initial settings on page 43.
2
Use MULTI-CONTROL to select
PIN CODE INPUT.
3
Push MULTI-CONTROL up or down to
select a number.
4
Push MULTI-CONTROL left or right to
move the cursor to the previous or next po-
sition.
5
After inputting PIN code (up to 16 di-
gits), press MULTI-CONTROL.
PIN code can be stored in memory.
When you press MULTI-CONTROL again on
the same display, the PIN code you entered is
stored in this unit.
# Pushing MULTI-CONTROL right in the confir-
mation display returns you to the PIN code input
display, and you can change the PIN code.
Editing device name
You can edit the device name.
The device name is set to PIONEER FLAP BT
as default.
1
Display the initial setting menu.
Refer to Adjusting initial settings on page 43.
2
Use MULTI-CONTROL to select
EDIT DEVICE NAME.
3
Press DISP to select the desired charac-
ter type.
Press DISP repeatedly to switch between the
following character types:
Alphabet—Numbers
4
Push MULTI-CONTROL up or down to
select a letter of the alphabet.
5
Push MULTI-CONTROL left or right to
move the cursor to the previous or next
character position.
46
En
6
Move the cursor to the last position by
pushing MULTI-CONTROL right after enter-
ing the device name.
Push MULTI-CONTROL right again to store
the device name in memory temporarily.
# Pressing MULTI-CONTROL can also store the
device name in memory temporarily. In this meth-
od, cursor doesn't need to be the last position.
# If an invalid character has been entered, sub-
sequent characters are not displayed.
# If an invalid character has been entered in the
beginning, device name cannot be stored in
memory.
Displaying system version
for repair
Should this unit fails to operate properly and
you consult your dealer for repair, you may be
asked to indicate the system versions of this
unit and of Bluetooth module. You can display
the versions and confirm them.
1
Display the initial setting menu.
Refer to Adjusting initial settings on page 43.
2
Use MULTI-CONTROL to select BT INFO.
The system (microprocessor) version of this
unit is displayed.
3
Push MULTI-CONTROL left to switch to
the version of the Bluetooth module of this
unit.
# Pushing MULTI-CONTROL right returns to the
system version of this unit.
Resetting the Bluetooth
wireless technology module
Bluetooth telephone and Bluetooth Audio
data can be deleted. To protect personal infor-
mation, we recommend deleting this data be-
fore transferring the unit to other persons. The
following settings will be deleted.
Hide quick links:
Advertisement
Table of Contents
