Cooling/Heating/Fan Only Operation; Drying Operation - York R91/BGE Owner's Manual

Cooling/Heating/Fan only operation

Drying operation

NOTE:
Start
Ensure unit is plugged and power is available.
The OPERATION lamp on the display panel of
the indoor unit starts flashing.
1. Mode select button (MODE)
Press to select COOL, HEAT (Not applicable
to cooling only models), or FAN.
2. Temperature button (TEMP)
Set the desired temperature, the most
comfortable temperature is between 21°C to
28°C.
3. Fan speed button (FAN SPEED)
Press to select "AUTO", "LOW", "MED" and
"HIGH".
4. ON/OFF button
When the remote controller is off, push this
button to start the air conditioner.
Stop
ON/OFF button
Push this button again to stop the air conditioner.
The FAN ONLY mode does not control temperature.
Therefore, perform only steps 1, 3, and 4 to
select this mode.
Start
Ensure unit is plugged and power is available.
The OPERATION indicator on the display panel
of the indoor unit starts flashing.
1. Mode select button (MODE)
Press to select DRY.
2. Temperature button (TEMP)
Push the TEMP button to set the desired
temperature, the most comfortable temperature
is between 21°C to 28°C.
3. ON/OFF button
When the remote controller is off, push this
button to start the air conditioner. No fan speed
indicator displays .The Indoor fan speed will
be automatically selected LOW.
Stop
ON/OFF button
Push this button again to stop the air conditioner.
Note: The fan speed cannot be adjusted when
the unit is in AUTO and DRY mode.
6
12/7/05 3:43:35 PM