Timer Operation - York R51 Owner's Manual

COOL , HEAT, and FAN ONLY Operation
1. If the AUTO mode is not comfortable , you may manually override
the settings by using COOL, DRY, HEAT( HEAT PUMP units only),
or FAN ONLY modes.
2. Push the TEMP button to set the desired room temperature.
When in COOLING mode, the most comfortable settings are 21 C
or above. When in HEATING mode, the most comfortable settings
。
are 28 C or below.
3. Push the FAN SPEED to select the FAN mode of AUTO, HIGH,
MED or LOW.
4. Push the ON/OFF button. The operation lamp lights and the air
conditioner starts to operate per your settings. Push the ON/OFF
button again to stop this unit operation.
NOTE
The FAN ONLY mode cannot be used to control the temperature. While
in this mode, only steps 1 3 and 4 may be performed.
DRY OPERATION
1. Push the MODE button to select DRY.
2. Push the TEMP button to set the desired temperature from
。 。
21 C to 28 C.
3. Push the ON/OFF button. The operation lamp lights and the air
conditioner starts to operate in the DRY mode. Push the ON/OFF
button again to stop this unit operation.
NOTE
Due to the difference of the set temperature of the unit and the
actual indoor temperature, the Air Conditioner when in DRY mode
will automatically operate many times without running the COOL
and FAN mode.

TIMER OPERATION

PUSH TIMER button to set the on and off times of the unit.
1. To set the STARTING time.
1.1 Please push the CANCEL button to cancel any former settings.
1.2 Push the TIMER button. The remote controller will show the
TIMER and the signal "h" is shown on the display panel. The
control is now ready to reset the TIMER ON to start the operation.
1.3 Push the TEMP button (
time .
1.4 After setting the TIMER there will be a one-half second delay
before the remote controller transmits the signal to the Air
Conditioner. Then, after approximately another 2 seconds ,the
set temperature will re-appear on the digital display.
、
or ) to set desired unit START
5
。