Cautions - York R91/BGE Owner's Manual

Automatic operation
J265_EN.indd 6
When you set the air conditioner in AUTO mode,
it will automatically select cooling, heating
(cooling only type without), or fan only operation
depending on what temperature you have
selected and the room temperature.
Once you select the operating mode, the
operating conditions are saved in the unit's
microcomputer memory.
Thereafter, the air conditioner will start operating
under the same conditions when you simply push
the ON/OFF button of the remote controller.
Start
Ensure the unit is plugged in and power is
available. The OPERATION indicator on the
display panel of the indoor unit starts flashing.
1. Mode select button (MODE)
Press to select AUTO.
2. Temperature button (TEMP)
Set the desired temperature. Normally, set it
between 21°C to 2 8°C
3. ON/OFF button
When the remote controller is off, push this
button to start the air conditioner.
Stop
ON/OFF button
Push this button again to stop the air conditioner.
If the AUTO mode is uncomfortable, you can
select the desired conditions manually.
When you select the AUTO mode, you do not
have to set the fan speed. The fan speed will be
automatically controlled.
5
Handling the r

CAUTIONS

• The air cond
block the sig
• Prevent any
the remote c
• If the infrared
the air condit
sunlight from
• If other elect
these applian