Using the net partition behind the front seats
ä
First read and observe the introductory information and safety warn-
ings
on page 71.
Pulling out
›
Fold the rear seats forward
» page
›
Pull the net partition by the bracket
›
First of all insert the cross rod into the mount
ward.
›
In the same way, insert the cross rod into the mount
vehicle.
Folding
›
First pull the cross rod back slightly on the one side and then on the other side
and remove it from the mounts
C
›
Hold the cross rod in such a way that the net partition can slowly roll up into
the housing
without being damaged.
B
›
Fold the rear seats back into their original position.
72
Using the system
Fig. 60
Pull out the net partition
64.
» Fig. 60
out of the housing
A
B
on one side and push it for-
C
on the other side of the
C
» Fig.
60.
Removing and installing net partition housing
ä
First read and observe the introductory information and safety warn-
ings
on page 71.
Removing
›
Fold the rear seats forward
›
.
Open the rear right door.
›
Push the net partition housing
remove it from the mounts on the rear seats in the direction of the arrow
Install
›
Insert the recesses on the net partition housing into the mounts on the rear
seat backrests.
›
Push the net partition housing in the opposite direction of the arrow
» Fig. 61
as far as the stop.
1
›
Fold the rear seats back into their original position.
Roof rack system
ä
Introduction
This chapter contains information on the following subjects:
Attachment points
Roof load
Fig. 61
Rear seats: Net partition hous-
ing
» page
64.
» Fig. 61
in the direction of the arrow
A
and
1
.
2
73
73
£