Status Indicators - Axis Q6034-E User Manual

Control button - The control button is used for
• Connecting to an AXIS Video Hosting System service, see page 34. To connect, press and hold the button until the
Status LED flashes green.
• Connecting to AXIS Internet Dynamic DNS Service, see page 34. To connect, press the button once.
• Restoring the camera to factory default settings, see
Power button - Press the button to temporarily power camera when dome cover is removed. The power button is also used
with the control button to restore the camera to the factory default settings, see
page 40.
Serial number label - Part number (P/N) and Serial number (S/N). The serial number may be required during installation.
SDHC Memory card slot - A standard or high capacity SD memory card (not included) can be used for local recording with
removable storage. To insert and remove an SD card, the camera's top cover must first be removed; for instructions please
refer to the Installation Guide.
Note:
Before removal, the SD card should be unmounted to prevent corruption of recordings. To unmount the SD card, go to
Setup > System Options > Storage > SD Card and click Unmount.

Status Indicators

After the startup and self test routines the indicators flash as follows.
Unit Color
AXIS Q6034-E Unlit
Amber
Amber/red
Red
Green
LED Indicator flash routine,
See also
Unit LED Color
Port
AXIS T8124 Unlit
Amber
Flashing
Green
AC input Steady green
Resetting to the Factory Default Settings,
Indication
Steady connection/normal operation
Steady for system initiating. Flashes during firmware upgrade or reset to
factory default.
No network connection
Firmware upgrade failure
Steady for 10 sec. after successful restart
on page 45.
Indication
No camera connected
Insufficient power for camera and heater. Check cable
Power overload
Camera connected, normal behavior
AC power connected
6
AXIS Q6034-E - Product Description
Resetting to the Factory Default Settings,
on page 40.
on