Blade Tracking - Grizzly G9743 Owner's Manual

Tighten the tension handle as tight as
7.
necessary so the blade will not slip on the
wheels during start up.
Put the gearbox in neutral by moving the gear
8.
change knob between two of the speed posi-
tions.
Spin the wheel by hand until the blade
9.
resumes the previous tracking.
10. Put the gearbox back in gear.
—If the tracking needs to be adjusted, refer
to the Tracking procedure in the next sec-
tion.
—If the tracking is fine, proceed to Blade
Tension on Page 34.

Blade Tracking

The blade tracking has been properly set at
the factory. The tracking will rarely need to be
adjusted if the bandsaw is used properly.
To adjust the blade tracking on the bandsaw:
UNPLUG THE BANDSAW!
1.
Raise the bandsaw to the highest position
2.
and close the feed rate ON/OFF valve.
3.
Remove both blade guide assemblies.
Open the wheel access cover.
4.
Loosen, but do not remove the lower cap
5.
screw in the blade wheel tilting mechanism
(Figure 37).
G9743 7" x 12" Metal-Cutting Bandsaw
Lower Cap Screw
Figure 37. Adjusting tracking set screw.
Relax the blade tension.
6.
Adjust the tracking set screw with a 4mm hex
7.
wrench as shown in Figure 37, then tighten
the cap screw loosened in Step 4.
—Tightening the set screw will move the
blade closer to the shoulder of the wheel.
—Loosening the set screw will move the
blade away from the shoulder.
Tension the blade.
8.
Put the gearbox in neutral by moving the
9.
gear change knob between two of the speed
positions and spin the wheel by hand.
—If the blade tracks along the shoulder of
the wheel (without rubbing), the blade is
tracking properly and this adjustment is
completed.
—If the blade drifts away from the shoulder
of the wheel or hits the shoulder, repeat
Steps 4-7.
10. Replace the blade guard and blade guide
assemblies.
11. Adjust the blade guides as needed. Refer to
Blade Guide Bearings on Page 35.
Tracking
Set Screw
-33-