Test Run; Recommended Adjustments - Grizzly G9743 Owner's Manual

Test Run

Projectiles thrown from
the machine could cause
serious eye injury. Wear
safety glasses during
assembly and operation.
Starting the machine:
1. Read the entire instruction manual.
2. Make sure all tools and foreign objects have
been removed from the machine.
3.
Put on safety glasses and secure loose
clothing or long hair.
4.
Connect the bandsaw to power.
5. Raise the bandsaw and close the feed ON/
OFF valve to keep the saw in place (see
Figure 10).
Feed ON/OFF
Valve
Figure 10. Feed ON/OFF valve and feed rate
dial.
6. Start the bandsaw while keeping your finger
near the ON/OFF switch at all times during
the test run (Figure 11). The bandsaw should
run smoothly with little or no vibration.
-18-
The adjustments listed below have been per-
formed at the factory. However, because of the
many variables involved with shipping, we recom-
mend that you at least verify the following adjust-
ments to ensure accurate cutting results.
Feed Rate
Step-by-step instructions on verifying these adjust-
Dial
ments can be found in SECTION 7: SERVICE
ADJUSTMENTS.
Factory adjustments that should be verified:
1. Blade Tracking (Page 33).
2. Squaring the Blade (Page 34).
3. Blade Guide Bearings (Page 35).
Note: If the EMERGENCY STOP button is
pressed, it needs to be twisted until it pops
out or the bandsaw will not start.
— If you suspect any problems, immediately
stop the bandsaw and correct before con-
tinuing.
—If you need any help with your bandsaw
call our Tech Support at (570) 546-9663.
Figure 11. ON/OFF switch.
Recommended
Adjustments
G9743 7" x 12" Metal-Cutting Bandsaw