Pppoe (Dsl) - D-Link AC750 User Manual

Section 3 - Configuration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a
username and password in this case. This option is typically used for DSL services. Make sure to remove any existing PPPoE
software from your computer. The software is no longer needed and will not work through a router.
My Internet Connection: Select PPPoE. (Username/Password) from the drop-down
menu.
Advanced DNS Service: Check the box to enable Advanced DNS Service.
Address Mode: Here the user can specify whether this Internet connection
requires the use of a Dynamic or Static.IP address. PPPoE
usually requires a Dynamic IP configuration.
IP Address: Enter the PPPoE IP address used here. This option is only
available if Static IP is selected.
Username: Enter the PPPoE account user name used here. This infor-
mation is given by the ISP.
Password: Enter the PPPoE account password used here. This informa-
tion is given by the ISP.
Verify Password: Re-enter the PPPoE account password used here.
Service Name: This optional field enables the user to enter a service name
to identify this Internet connection here.
Reconnect Mode: Use the radio buttons to specify the reconnect mode. The
user can specify a custom schedule or specify the On.De-
mand, or Manual option. To specify a custom schedule, use
the drop-down menu to select one of the schedules that
has been defined in the Schedules page.
D-Link DIR-810L User Manual
Internet Setup

PPPoE (DSL)

31