Table of Contents
Advertisement
Guard
To mount the cutter guard to the table, place the
guard over the threaded holes on the table, and
insert the shaft guide into the guard as shown in
Figure 13. Thread the shaft guide clockwise to
secure the guard to the table.
Figure 13. Inserting shaft guide into guard.
Insert the adjustment guide into the screw brack-
et. Line up the shaft groove shown in Figure 12
with the center bolt and screw the bolt into the
groove as shown in Figure 14. Do not complete-
ly tighten the bolt. This will allow the shaft to spin
without coming out.
Figure 14. Tightening bolt into shaft groove.
-14-
Fence Assembly
To mount the fence brackets to the guard body:
1.
Make sure all rust protective grease has
been removed from the fence pieces. Insert
the adjustment shaft into the fence bracket
as shown in Figure 15.
Figure 15. Adjustment shaft to fence bracket.
2.
Insert the adjustable handle (Figure 16) into
the fence bracket, and thread it into the
guard body.
Figure 16. Adjustable handle.
G8622 Tilting Spindle Sliding Table Shaper
Advertisement
Table of Contents
