Handles - Grizzly G8622 Instruction Manual

Handles

The guard adjuster is used to secure the guard to
the table and to allow the guard to be loosened
for adjustment. To assemble the guard adjuster:
1. Install the bar into the guide shaft as shown
in Figure 9.
2. Line up the groove in the bar with the
setscrew.
Figure 9. Slide bar into guide shaft.
3.
Tighten the shaft setscrew into the groove to
lock the bar in place as shown in Figure 10.
Figure 10. Tightening setscrew with hex key.
G8622 Tilting Spindle Sliding Table Shaper
Groove
4. Install the round knobs shown in Figure 11
onto both ends of the bar.
Figure 11. Thread round knobs onto bar.
The wheel shown in Figure 12 fits on the adjust-
ment shaft. This locks in place by tightening the
setscrew into the groove on the shaft. There is a
threaded hole on the wheel that allows for the
optional installation of a crank (not included). The
completed assembly is used to adjust the fence.
Setscrew Groove
Shaft
Groove
Figure 12. Installing wheel onto adjustment guide.
Setscrew
-13-