Advertisement
II. ASSEMBLY / DISASSEMBLY INSTRUCTIONS
A. Assembling the Continuous Feed Attachment
STEP #1 Unplug the machine. Place the motor base assembly at a comfortable height on a sturdy
work surface. Remove the plastic discharge plate from inside the continuous feed attachment. Place the
continuous feed attachment on the motor base with the release button at front center of the motor base
assembly. Rotate the attachment counterclockwise until it locks into place with a snap action. When the
attachment is in the proper position, it should be level with the top surface of the motor base assembly.
NOTE: The machine will not operate correctly unless the continuous feed attachment is fully seated and
secured in place.
STEP #2 Place the discharge plate on the motor shaft with the appropriate side up. Use the side
with the small straight fins for all julienne cuts or other delicate cuts. The large finned side may be used for
dicing or shredding. The product will not exit the machine without the discharge plate.
STEP #3 IF YOU ARE PREPARING TO SLICE OR JULIENNE: Place the plate of your choice
on the motor shaft and turn clockwise until it drops into place and is fully seated. The top of the plate
should be just above the surface of the continuous feed attachment.
Page 2
R6VN series D Operation Manual
Advertisement
