Technical Information - AEG L 75480 WD User Manual

www.aeg.com
6
• Make sure not to cause damage to the
mains plug and cable.
• Connect the mains plug to the mains
socket only at the end of the installa-
tion. Make sure that there is access to
the mains plug after the installation.
• Do not pull the mains cable to discon-
nect the appliance. Always pull the
mains plug.
• Only for UK and Ireland. The appliance
has a 13 amp mains plug. If it is neces-
sary to change the fuse in the mains
plug, use a 13 amp ASTA (BS 1362)
fuse.
• Permanent connection. To connect
the appliance permanently, install a
double-pole isolating switch between
the appliance and the electricity supply.
It must have a minimum distance of 3
mm between the switch contacts and it

TECHNICAL INFORMATION

Dimensions
Electrical connection:
Level of protection against ingress of solid particles
and moisture ensured by the protective cover, except
where the low voltage equipment has no protection
against moisture
Water supply pressure
Water supply
Maximum wash load
Maximum dry load
Spin speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
Width / Height / Depth
Total depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
1)
Cotton
Cotton
Synthetics
Maximum
must be the correct type for the neces-
sary load. It must agree with the last
electrical legislation. The switch must
not break the yellow and green ground
cable.
Only a qualified electrician must install
this type of device.
DISPOSAL
WARNING!
Risk of injury or suffocation.
• Disconnect the appliance from the
mains supply.
• Cut off the mains cable and discard it.
• Remove the door catch to prevent chil-
dren and pets to get closed in the ap-
pliance.
600 / 850 / 605 mm
640 mm
230-240 V
2200 W
13 A
50 Hz
IPX4
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Cold water
8 kg
6 kg
3 kg
1400 rpm