Switching The Telephone Muting/Attenuation Setting; Setting The Fm Tuning Step; Setting The Am Tuning Step; Setting The Warning Tone - Pioneer DEH-P9450MP Operation Manual

Initial Settings
S
witching the telephone
muting/attenuation setting
When a call is made or received using a cellular
phone connected to this product, the product
can be set to either mute or attenuate the audio
output.
1. With the source turned off, press and
hold 1.
2. Press MUTE.S to select the telephone
muting/attenuation mode.
3. Press MUTE.S to select the desired set-
ting.
Press MUTE.S repeatedly to switch between
the following settings:
TEL mute = 10dB ATT = 20dB ATT
Sound from this product is muted or attenu-
ated automatically when a call is made or
received using a connected cellular tele-
phone.
• "20dB ATT" has a stronger effect than
"10dB ATT", and "TEL mute" has a
stronger effect than "20dB ATT".
S
etting the FM tuning step
The FM tuning step during seek tuning can be
switched between 100 kHz (the factory preset
step) and 50 kHz.
1. With the source turned off, press and
hold 1.
2. Press NEXT and then press FMstep to
select the FM tuning step mode.
3. Press the corresponding button to select
the desired tuning step.
Button Tuning step
50K 50 kHz
100K 100 kHz
Note:
• If seek tuning is performed at 50 kHz steps, stations
may be tuned in imprecisely. Tune in the stations
with manual tuning or use seek tuning again.
45
S
etting the AM tuning step
The AM tuning step can be switched between 9
kHz and 10 kHz per step. Reset the AM tuning
step from 9 kHz (the factory preset step) to 10
kHz when using the tuner in North, Central or
South America.
1. With the source turned off, press and
hold 1.
2. Press NEXT and then press AMstep to
select the AM tuning step mode.
3. Press the corresponding button to select
the desired tuning step.
Button Tuning step
9K 9 kHz
10K 10 kHz
Note:
• If you switch the tuning step, the frequency range is
changed simultaneously.
S
etting the warning tone
The warning tone sounds to remind you to
detach the front panel. (Refer to page 9.)
You can turn the warning tone function on or
off.
1. With the source turned off, press and
hold 1.
2. Press NEXT and then press DT-WRN to
select the warning tone mode.
3. Press DT-WRN to turn the warning tone
on.
"ON" appears in the display.
• Press DT-WRN again to turn the warning
tone off.