GE Monogram ZBD6605 Owner's Manual page 24

Questions? PROBLEM
Use this
Black or gray marks
on dishes
problem
Dishes do not dry
solver
Chef's Washer won't start Door not properly closed
All cycle status indicators
flashing or beeping every
30 seconds (on ZBD6905,
ZBD 7005 and ZBD 7105)
Motor starts but water
doesn't enter Chef's
Washer (flashing POTS
LIGHT) (on models
ZBD 6905, ZBD 7005
and ZBD 7105)
Program taking too
long or not advancing
properly
24
Before You Call For Service
POSSIBLE CAUSE
Aluminum utensils have
rubbed against dishes
HEAT/SMART DRY
not selected
Rinse agent dispenser
is empty
Chef's Washer is paused
Low inlet water
Door opened during cycle • Re-latch door. Wait a few minutes; Chef's
when water is hot
Child Lockout mode
is selected
Power supply not connected • Check that Chef's Washer is plugged in and
Door not properly closed
Chef's Washer is paused
Water supply valve
turned off
Low inlet water temperature • Run tap until water is hot prior to starting
Chef 's Washer
WHAT TO DO
• Remove marks with a mild, abrasive cleaner.
• Depending on model, select HEAT DRY
or SMART DRY.
• Check the rinse agent dispenser.
• To restart the wash cycle, press the selected
wash button.
• Run tap until water is hot prior to starting
Chef's Washer cycle.
• Assure inlet water temperature is at
least 120°F.
• Depending on your model, select WATER
TEMP HIGH & HEAT DRY or WATER
TEMP SANI and HEAT DRY options.
• Press door until it clicks shut.
Washer will restart automatically.
• Press and hold desired button for two
seconds. See Child Lockout mode section
for models ZBD6905, ZBD 7005 and ZBD 7105.
switch is on.
• Press door until it clicks shut.
• To restart the wash cycle, press the selected
wash button.
• Open water supply valve.
Chef's Washer cycle.
• Allow time to heat water (up to one hour).
• Check inlet water temperature.
• Connect to hot water supply.