Abit IT5A User Manual page 59

Quick Installation
Installing CPU Fan Power connector:
orientation. Connect the three-threads CPU Fan power cable to the Fan
connector on the mainboard.
FAN1
Pin number
FAN2
Pin number
For the IT5A, if the CPU Fan power has only two threads, connect them to PIN2
and PIN3
Adjusting other jumpers:
normal operation. Adjust them according to the following recommendations.
CCMOS ¡G Put jumper on pin 1 and pin 2.
BIOS Setup:
following message displayed:
Press immediately Del key to enter BIOS Setup. Select Load Setup Defaults,
than enter CPU Soft Menu to set CPU parameters.
Name of the signal or signification
1 Control on / off
2 +12V
3 Sensor signal
Name of the signal or signification
1 Control on / off
2 +12V
3 Sensor signal
Parameters and CPU settings After you have followed the
steps described above and completed the installation,
when you power the computer on, you will see the
PRESS DEL TO ENTER SETUP
FAN1 - There is a specific
Some jumpers are reserved for future
functions or are not to be adjusted in
A-5