CHECKING THE BULBS AND BULB SOCKETS
WARNING
Since the headlight bulb gets extremely
hot, keep flammable products and your
hands away from the bulb until it has
cooled down.
CAUTION:
Be sure to hold the socket firmly when
G
removing the bulb. Never pull the lead,
otherwise it may be pulled out of the ter-
minal in the coupler.
Avoid touching the glass part of the head-
G
light bulb to keep it free from oil, other-
wise the transparency of the glass, the
life of the bulb and the luminous flux will
be adversely affected. If the headlight
bulb gets soiled, thoroughly clean it with
a cloth moistened with alcohol or lacquer
thinner.
2.Check:
Bulb (for continuity)
G
(with the pocket tester)
No continuity → Replace.
Pocket tester
P/N. YU-03112, 90890-03112
NOTE:
Before checking for continuity, set the pocket
tester to "0" and to the "Ω × 1" range.
*****************************************************
a.Connect the tester positive probe to terminal
and the tester negative probe to terminal
, and check the continuity.
b.Connect the tester positive probe to terminal
and the tester negative probe to terminal
, and check the continuity.
c.If either of the readings indicate no continu-
ity, replace the bulb.
*****************************************************
9 - 7
–
+
ELEC