PRESONUS StudioLive 16.4.2 User Manual page 118

6 Technical Information
Troubleshooting
6. 1
Fader Movements have no effect on audio
Verify that your StudioLive is not locked by navigating to Page 4: Lockout in the System Menu.
Verify that your StudioLive is not in Fader Locate mode. Select Output in the Metering Section and
verify that your fader movements are affecting the output signal. If so, make sure your channels are
assigned to the Main outputs.
No Internal Effects in the Main Bus
Press the Aux button in the Metering section and verify the output levels of the internal EFX A and
B aux buses. If the level is too low, use the Output knob to increase the master level for the effects
mix. Press the Select button for each EFX bus and make sure it is assigned to the main output in
the Assign section of the Fat Channel.
No output on the Solo bus while monitoring
Verify that both the Cue volume and the headphone or monitor volume is at a reasonable level for
comfortable listening. Make sure that you only have Solo selected in the Monitor Section of your
StudioLive.
118