Programming - Culligan Gold Series Owner's Manual

12

Programming

The Culligan® AccuSoft® Plus circuit board controls all of the softener functions. These set-
tings are programmed at the time of installation. The following is a list of all the microproces-
sor functions, in the event that any of the settings need to be adjusted.
1. Beeper Setting - This setting is used to turn the beeper on
or off for each key press actuation. The display will show
"bEEP X" where X is either "Y" or "N". The "Y" or "N" will
be toggled with the "+" and "-" keys. Setting the Beep
option to "N" will only disable the beeper for key press
actuation. The beeper will still be active for error and
alarm codes.
Pressing the "Status" key will save the setting and move to the next programming step.
2. Time of Day - This setting is used to program the current
time of day. When in this step the display will first show
"tod" for two seconds.
After "tod" is displayed, "12:00 PM" will display (or the
current set time if already programmed) and the minutes
will flash. The minutes are adjusted with the "+" or "-" key
until the correct value is displayed.
Press the "Regen" key to flash the hours. Adjust with the
"+" or "-" key until the correct time is displayed.
Pressing the "Status" key will move to the next program-
ming step. Pressing "Regen" will move back to the minutes
adjust.
3. Time of Regeneration - This setting is used to program
the time at which a regeneration is to occur in the delay
mode, or in immediate mode with time clock backup on.
The display will first show "tor" for two seconds.
After "tor" is shown the display will then show the default
of 2:00 AM (or the current programmed time of regenera-
tion if already set). The time can be adjusted in 30 minute
increments by pressing the "+" or "-" keys.
Pressing the "Status" key will save the setting and move to
the next programming step.
2 : 00
AM