Table of Contents
Advertisement
SECTION 6: MAINTENANCE
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person-
al injury.
Schedule
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily Check:
•
Clean unpainted cast iron parts of jointer and
planer tables
•
Lubricate feed rollers
Weekly Check:
•
Clean cutterhead
Monthly Check:
•
Inspect V-belt tension, damage, or wear
•
Clean/vacuum dust buildup from inside cabi-
net and off motor
•
Lubricate worm gear
•
Lubricate roller chains
•
Lubricate elevation lead screw
•
Lubricate worm shaft
Cleaning
Vacuum excess wood chips and sawdust, and
wipe off the remaining dust with a dry cloth—this
ensures moisture from wood dust does not remain
on bare metal surfaces. Treat all unpainted cast
iron and steel with a non-staining lubricant after
cleaning. We recommend products like SLIPIT
G96
Gun Treatment, or Boeshield
®
Page 32 for more details).
-34-
V-belt removal and replacement involves remov-
ing the V-belts, rolling them off of the pulleys,
replacing them with new belts, then retensioning
them.
Always replace V-belts as a set, or belt tension
may not be even among the belts and may cause
premature belt failure.
Consider replacing stock belts with Power Twist
V-belts (see Page 32) to reduce vibration and
noise, and increase belt lifespan.
To adjust/replace belts the V-belts:
1.
2.
Figure 46. Removing bolts on V-belt cover and
3.
,
®
T-9 (see
®
G0633/G0634 Jointer/Planer Combo Machine
V-Belts
DISCONNECT
THE
FROM THE POWER SOURCE!
Remove the four hex bolts securing the V-
belt cover (see Figure 46).
belt tension knob (inset).
Remove the fence and fence bracket, then
remove the motor access cover and belt ten-
sion knob (Figure 46).
JOINTER/PLANER
Advertisement
Table of Contents
