Gemini PS-828EFX Operation Manual page 5

CONTROLS:
(CONTINUED)
13
The
individual channel depending on how low or high its input level is
14
The
ing you a choice frequencies (
and
higher or lower the 3 separate frequencies till the sound of the music
program is appropriate for your listening environment.
15
After you have chosen which input you will use with the
the corresponding
adjust the volume for that particular
16
The fader assignment push button allows you to assign which two
channel faders will be controlled by the
sition the
the down or pushed in position the
channels ( ) and ( ). The
choose between two fader
the right will give you a gradual
switch to the left will give you a quick
17
The allows you to mix evenly from one source to an-
other. On the
either channels (1) and (2) or channels (3) and (4) depending on the
position of the fader assignment push button (see above).
The on the
need arises can be replaced.The RG-45 (RAILGLIDE™)
rails that allow the slider to ride smoothly and accurately from end to
end can be purchased from your local
18
The has a
monitor the decibel levels of its input, you also have a master output
that lets you monitor the decibel levels of the
output.
19
The has two display modes, in
the level of the channel you are cueing, in
the main output.
20
The
output.
21
The
22
The CUE VOLUME ROTARY KNOB adjusts your HEADPHONE
MONITOR OUTPUT'S volume.
19 23
The
which channel you wish to monitor in your headphones by pressing
this switch on any channel you will be able to listen to that channels
input in your headphones multiple
pressed to monitor more than on input at a a time.
allows you to boost the signal of each
adjust the tone of each
) to adjust , from
,you can use the adjustment knobs to
will allow you to
.
in the UP po-
will fade between channels (1) and (2), in
will fade between
selector lets you
settings, positioning the switch to
and positioning the
.
The is assignable between
is also removable and if the
, which has internal dual stainless steel
dealer.
on each channel that allows you to
mode it will display
mode it displays
knob adjust the volume of the
determines the mix between the chosen
and the mix.
allows you to choose
EFFECTS:
24 19
The
by pressing its respective button, once an effect is chosen a red LED
light will illuminate indicating the effect is engaged you may then
change its parameters with the
Each effect only engages momentarily then defaults back to (0)
L by giv-
effect, you can keep the effect from defaulting by pressing the
button located above the effects buttons, the
the effect indefinitely until you either disengage the button or engage
a new effect. The
25
The
depth and speed of an effect like with the
or what the effect does like with the
With the
much the filter will cut, for example if you spin the
the way to the left the filter will cut off all the HIGH frequencies
leaving only the
filter will cut off all the
With the
deep the flanger will sound. Turn the wheel either way just a little
and the
either direction, the
you the tunnel or jet plane sound effect.
Or
on fast or slow depending where the
giving you a
either direction just a little and the effect will cut the music volume up
and down slowly, keep turning the wheel in either direction and the
effect will cut the music volume up and down quickly, you can then
adjust the speed of the transfom effect to match the tempo of your
music.
26
The
and
to that channels signal individually to the effect section of the
mixer, any combination of the four can be applied and all can send at
once.
can be
PS-828EFX
has three effects and any one effect can be chosen
LED will illuminate when
allows you to adjust either the
.
the
, and if you spin it all the way to the right, the
leaving just the
the
is barely audible, the more you turn the wheel in
will get deeper sounding and give
effect will turn the volume of the track off and
sounding effect. Turn the wheel in
has an on each channel that allows you
jog wheel.
button will hold
is engaged.
and
controls how
all
end frequencies.
controls how
is,
5