Use Instructions For Accessory Discs In The Continuous Feed Chute - Waring FP25 Operation Manual

Turn the Machine OFF with the OFF lever.
• Always switch the food processor off by pressing and releasing the PULSE/OFF lever. This assures that
the power is not supplied to the motor.
• Always switch the food processor off and wait until rotation stops before removing the cover.
• While the safety interlock switch will turn the machine off if the cover is rotated clockwise, or the cover is
removed while running, this should not be the means of ON/OFF operation.
• Before rotating the lid, always make sure the machine is off by pressing the PULSE/OFF lever as a
safety precaution, in the event that the machine was not turned off properly.
• When processing, it is recommended that the machine be operated on a 50% duty cycle, such as
5 minutes on/5 minutes off. This can be accomplished by processing for 5 minutes, then doing
5 minutes of food preparation. Please remember to turn off the machine when not in use.
16
USE INSTRUCTIONS for ACCESSORY DISCS
in the CONTINUOUS FEED CHUTE
FP25 & FP25C
• Assemble the bowl and accessory disc as instructed in the section titled, "Assembly of Batch Bowl Parts,"
(see page 8). Or, assemble the continuous feed chute and accessory disc as instructed in the section titled
"Assembly of Continuous Feed Chute Parts," (see page 11).
• If required by your processing task, either:
• Stack the feed tube with food and position the large food pusher at the top of the stack,
or
• Place the large food pusher into the feed tube and remove the small feed pusher to use the smaller
feed chute located inside the large food pusher. This is described above (see page 12). Stack food
items in the small food chute. Position small food pusher at the top of the stack.
• Be sure the unit is off by pushing and releasing the PULSE/OFF lever.
• Insert the power cord plug into a properly grounded outlet of the correct voltage.
• Use the ON switch for continuous processing, or the PULSE/OFF lever for pulsing /on-off operation.
• Feed the items to be processed at a steady rate into the feed tube, using the food pusher to push the food
down. The same technique is used whether you choose to use the large pusher or the small pusher. Avoid
excessive force when using either one of the food pushers. Too much force may cause food items to jam in
the feed tube or damage the machine. ALWAYS USE THE LARGE FOOD PUSHER TO PUSH
FOOD ITEMS DOWN INTO THE LARGE FEED TUBE. IN THE SAME WAY, ALWAYS
USE THE SMALL FOOD PUSHER TO PUSH FOOD ITEMS DOWN INTO THE SMALL
FEED TUBE. NEVER PUT FINGERS, SPATULAS, OR OTHER UTENSILS INTO THE
LARGE FEED TUBE OR THE SMALL FEED TUBE CHANNEL.
• Never use the small food pusher in the large feed tube.
• When the bowl is full and / or you have finished your processing task with the bowl or continuous feed
chute, press the PULSE / OFF lever and let the processing disc come to a complete stop. Unplug the
unit. NEVER STOP THE FOOD PROCESSOR BY REMOVING THE PLUG FROM THE
OUTLET OR BY REMOVING THE COVER. ALWAYS STOP THE UNIT BY PRESSING
THE PULSE/OFF LEVER.
• Follow disassembly instructions for the bowl and continuous feed chute as appropriate. These are
described in the section titled "Disassembly of Batch Bowl Parts," (see page 10), or the section titled
"Disassembly of Continuous Feed Chute Parts," (see page 12).
When processing, it is recommended that the machine be operated on a 50% duty cycle, such as 5 minutes
on / 5 minutes off. This can be accomplished by processing for 5 minutes, then doing 5 minutes of food
preparation. Please remember to turn off the machine when not in use.
17