Download
Share
Print this page
SWR WORKINGMAN’S 2004 Owner's Manual
  1. Manuals
  2. Brands
  3. SWR Manuals
  4. Amplifier
  5. WORKINGMAN'S 2004
  6. Owner's manual

SWR WORKINGMAN’S 2004 Owner's Manual

Bass amplifier head
Hide thumbs Also See for WORKINGMAN’S 2004:

Advertisement

Quick Links

Download this manual
S W R
S O U N D
C O R P O R A T I O N
WORKINGMAN'S 2004
OWNER'S MANUAL
SWR SOUND CORPORATION
SWR SOUND CORPORATION
9130 GLENOAKS BLVD.
SUN VALLEY, CA 91352
PHONE: (818) 253-4797
FAX: (818) 253-4799
EMAIL: SUPPORT@SWRSOUND.COM
©1999, 2002 SWR SOUND CORPORATION
WEB: WWW.SWRSOUND.COM
PART # 320028 REV. 4/02

Advertisement

loading

Related Manuals for SWR WORKINGMAN’S 2004

Summary of Contents for SWR WORKINGMAN’S 2004

  • Page 1 C O R P O R A T I O N WORKINGMAN’S 2004 OWNER’S MANUAL SWR SOUND CORPORATION SWR SOUND CORPORATION 9130 GLENOAKS BLVD. SUN VALLEY, CA 91352 PHONE: (818) 253-4797 FAX: (818) 253-4799 EMAIL: SUPPORT@SWRSOUND.COM ©1999, 2002 SWR SOUND CORPORATION WEB: WWW.SWRSOUND.COM PART # 320028 REV. 4/02...
  • Page 2 SWR product. We truly hope that your purchase of an SWR helps bring out the best in your playing and adds to your enjoyment of music.
  • Page 3 If you hear a small amount of distortion and the Preamp Clip LED is not activated, try using the Active input jack. And please note, some passive pickups DO distort. Because of the hi-fi nature of all SWR products, even the smallest amount of distortion originating at the source (instrument) may be heard.
  • Page 4 FRONT PANEL FEATURES (continued) ACTIVE INPUT The Active input jack should be used with instruments having a built-in (on-board) preamp that will produce signals over 1 volt RMS. Known basses that should use the Active input only are the Kubicki X-Factor and some Ovation electrics.
  • Page 5 FRONT PANEL FEATURES (continued) BASS CONTROL The Bass control itself, as stated above, works in a range that will be useful under most "normal" conditions. Its musical use might be thought of as a "fatness" control. Leaving the Aural Enhancer in a posi- tion lower than 12 o'clock will not boost the extreme bottom so much as to make indistinct the working of the Bass control.
  • Page 6 FRONT PANEL FEATURES (continued) EFFECTS BLEND CONTROL The Effects Blend control mixes the signal coming from your instrument with the sound coming from your effect. With the Blend control fully counter-clockwise, no signal from your effect will be heard. As you turn this control clockwise, more of the effect can be heard in the overall sound.

  • Page 7: Rear Panel Features

    FRONT PANEL FEATURES (continued) STEREO HEADPHONES JACK By inserting a set of stereo headphones into this jack you will be able to monitor your sound or practice without disturbing your neighbors. The headphone volume level is adjusted by the Master Volume. We sug- gest you begin with the Master Volume full off (counter-clockwise), then slowly bring up the volume to the desired level.
  • Page 8 The total impedance of the speakers should be 4 Ohms or greater. This means you can use one 4 ohm cabinet, two 8 ohm cabinets or four 16 ohm cabinets. RECOMMENDED SPEAKER ENCLOSURES FROM SWR INCLUDE: Any two of the following 8 ohm enclosures: Workingman's 2x10T, Workingman's 4x10T, Workingman's 1x15T, Goliath III, Son Of Bertha, Big Ben Subwoofer and Goliath Jr.
  • Page 9 S W R S O U N D C O R P O R A T I O N Suggested Settings: Workingman’s 2004 Suggested Settings: Workingman’s 2004...

  • Page 10: Limited Warranty

    In the case where the unit must be shipped, pack your unit carefully (using original packaging whenever possible), and include a copy of your bill of sale. Ship the unit PREPAID to the SWR Authorized Service Center of your choice.