Central Pneumatic 56101 Owner's Manual & Safety Instructions page 10

5. To start a cold engine, move the Choke to the CHOKE (start/
closed) position.
To restart a warm engine, leave the Choke in the
RUN position.
For MANUAL START
6.
a. Turn the Engine Switch to ON.
ON
OFF START
b. Grip the Starter Handle of the Engine loosely and
pull it slowly several times to allow the gasoline
to flow into the Engine's carburetor. Then pull
the Starter Handle gently until resistance is felt.
Allow Cable to retract fully and then pull it quickly.
Repeat until the engine starts. Note: Do not let
the Starter Handle snap back against the engine.
Hold it as it recoils so it doesn't hit the engine.
7. Allow the Engine to run for several seconds.
Then, if the Choke lever is in the CHOKE position, move
the Choke Lever very slowly to its RUN position.
Note: Moving the Choke Lever too fast could kill the engine.
8. Close the Pilot Valve by rotating it to a horizontal position.
Page 10
ON
For technical questions, please call 1-800-444-3353.
5
For ELECTRIC START
Turn the Engine Switch to START.
Note: To prolong starter life, use short starting
cycles (5 seconds maximum). Then wait one
minute before attempting to start again.
ON
OFF START
7
START
8
Item 56101