Headstock Gears - Grizzly G9249 Owner's Manual

Headstock change Gears
Lubricant frequency
Multi-purpose every
gear grease 8 hours
of operation
Add one pump from a grease gun to the three
headstock grease fittings shown in figure 80.
use a brush to apply a thin coat of grease to the
gear teeth.
figure 80. headstock grease fittings.
Headstock Idler Pulley Shaft
Lubricant frequency
Multi-purpose every 8 hours
gear grease of operation
Add one pump from a grease gun to the idler pul-
ley grease fitting shown in figure 81.
idler pulley shaft
grease Fitting
figure 81. headstock pulley shaft lubrication
points.
-48-
Qty
one pump to
Fittings;
thin Coat to
gears
grease
Fittings
Qty
one
pump
Back spindle
gears gears
spindle pulley
shaft set screw

Headstock Gears

Lubricant
Multi-purpose gear
grease
use a brush to apply a thin coat of grease to the
gear teeth of the spindle and back gears (see
figure 81).
Headstock Spindle Pulley Shaft
Lubricant
iso 68 sAe 20W
Bearing and gear
lubricant
remove the spindle pulley shaft set screw shown
in figure 81, add 2–3 drops of lubricant, then re-
install the set screw.
feed Rate Gearbox Oil
Lubricant
iso 68 sAe 20W
Bearing and gear
lubricant
remove the oil plugs on either side of the control
panel (see figure 82), add 2–3 drops of lubricant,
then replace the oil plugs.
oil plugs
figure 82. Feed rate gearbox oil plugs.
g9249 12" x 37" Belt drive gap Bed lathe
frequency Qty
every thin
8 hours Coat
of operation
frequency Qty
every 2–3
8 hours drops
of operation
frequency Qty
every 2–3
8 hours drops
of operation