Alfa Romeo 166 Booklet page 180

ADDITIONAL STOP LIGHT
(3 rd STOP)
To replace the bulbs (Type A, 2.3 W):
– Remove the rubber caps (A-
fig. 63).
fig. 63
fig. 64
180
– Slacken the two screws fastening the
light unit (B-fig. 64) and remove it re-
leasing the two catches (C).
– Disconnect the connector (D-
fig. 64) of the light unit.
– Slacken the two screws (E-fig. 65)
and separate the light unit from the cov-
er.
fig. 65
fig. 66
– Slacken the four screws (F-fig. 66)
fastening the transparent cover.
– Remove the transparent cover (G-
fig. 67) and replace the bulb concerned
– Refit the transparent cover locking it
with the screws (F-fig. 66).
– Refit the cover on the light unit and
fasten it with the screws (E-fig. 65).
– Connect the connector (D-fig. 64).
– Re-position the unit correctly firstly in-
serting the two catches (C-fig. 64) and
then tightening the fastening screws.
– Refit the protective caps (A-
fig. 63).
fig. 67