Cam Title - EverFocus EQ610x User Manual

EQ610x
N->D LEVEL: Select the light level at which the camera will switch from Night
mode to Day mode.
N->D DELAY: Set the number of seconds that the camera will wait when the
N/D change level is reached. In other words, this will be the length of time
that the selected light level will have to be sustained before the camera will
react.
B&W
BURST: Switch burst mode on or off here.
6.7 SPECIAL
Scroll down to the SPECIAL menu item and press Enter to enter the submenu.
Here you can configure the CAM TITLE, MOTION, PRIVACY, PARK. LINE,
COMM ADJ., DPC, and VERSION settings.

CAM TITLE

Select ON to display the camera's title on the screen. Press Enter to enter the
create or change the title. Use your direction buttons to navigate between
the digits. Use your Enter button to select and confirm items. Use CLR to
clear the whole title. Use the two Left and Right arrows to move the in-title
cursor and change separate digits by selecting new digits. Select POS to move
the position of the camera title to where you want it to be displayed on the
screen (the title will start flashing in its current position when you click POS,
use your direction buttons to move it to the desired position). Select END to
return to the SPECIAL submenu.
MOTION
Here you can select ON to switch Motion Detection on. Now you can press
Enter to open the Motion submenu and configure area blocks where motion
will be detected.
AREA SEL.: Select the number of one of the four preconfigured area blocks
that you want to select. The corresponding block will start to flash when you
select its number.
AREA STATE: Switch the selected area block on or off. Off means that motion
will not be detected in that area.
HEIGHT: Adjust the height of the selected area block.
WIDTH: Adjust the height of the selected area block.
13