Table of Contents
Advertisement
I
NSTALLATION OF
M
1. Remove the two screws affixing the
Microphone Jack cover, and then re-
move the Microphone Jack cover from
the Front Panel.
2. Remove the four screws securing the
Rear Case of the Front Panel and remove
the Rear Case from the Front Panel.
Note: When you remove the rear case,
you will find a small thin wire near the
flat ribbon cable. Be careful not to cut or
add any stress to this wire. It will be con-
nected in step 4.
102
O
J
ICROPHONE
A
PTIONAL
"MEK-M10"
ACK
3. Attach the "MEK-M10" to the Front
Panel using the previously removed
two screws.
Note: When securing the MEK-M10 to
the front panel, make sure that the rub-
ber gasket is free of any contaminants
and properly seated before securing the
MEK-M10 with the screws. This will
insure that moisture or water does not
enter the front panel.
4. Attach the Flat cable to the connector
on the Printed Circuit Board, and con-
nect the Wire from the "MEK-M10" to
the Wire from the Printed Circuit Board
in the front panel.
Note: Please adjust the terminal side of
the flat cable to the lower side of the
connector on the Printed Circuit Board,
and insert it in the connector.
Connector
5. Replace the Rear Case to the Front
Panel using the previously removed
four screws.
FTM-10SR O
CCESSORIES
Connect Wires
M
PERATING
ANUAL
Advertisement
Table of Contents
