Multiple System Setup; Manual Frequency Selection (Receiver Only) - Shure PGX Wireless User Manual

Multiple System Setup

Multiple system setups require the use of groups and channels. In the
See the included
frequency and
LED panel, the left digit indicates the current group; the right digit indi-
channel guide
cates the current channel.
for information
on compatible
channels.
left digit is group
Follow these steps when using multiple PGX systems in a single installation:
1.
2.
3.
4.
5.
Leave the transmitter turned on. Repeat for each system.
Be sure that only one transmitter's IR port is exposed when
synchronizing a system.

Manual Frequency Selection (receiver only)

To manually select a group or a channel, press and hold the channel button.
The display alternates between the group number and the channel number.
hold channel
Releasing the channel button while either number is displayed makes the
displayed number flash.
Pressing the channel button while either number is flashing increases the
setting by one.
to change the group
value, release the
channel button while
the first digit displays...
to change the channel
value, release the
channel button while the
second digit displays...
To activate a newly selected group or channel, simply wait until the number
stops flashing.
Turn all receivers on and all transmitters off.
Make sure the group number is the same for all receivers. If nec-
essary, use Manual Frequency Selection (shown below) to set all
receivers to a single group.
Perform Automatic Frequency Selection on the first receiver
(see page 6).
Turn on the first transmitter.
Perform Automatic Transmitter Setup (see page 6).
button
7
ENGLISH
right digit is channel
...then press the
channel button
to increase the
value.
...then press the
channel button
to increase the
value.