Warnings; Hook-Up Information - Mr. Heater MH30T Operating Instructions And Owner's Manual

HOOK-uP InFOrMaTIOn

1.1 Heater model MH30T and MH30TS are packaged completely
assembled. Propane cylinders are not included with heater
models.
1.2 Remove heater assembly from carton.
1.3 Align bolt holes in tank collar bracket with bolt holes in center
plate on manifold.
1.4 Attach with supplied screws.
CauTIOn:
BE SURE THE LOCKING KNOB ON THE COLLAR
MOUNTING BRACKET ASSEMBLY IS OUTSIDE THE
COLLAR ON THE BULK TANK. Tighten the black knob
against collar of tank.
1.5 Place the slots of the black collar mounting bracket assembly
onto the collar of the bulk tank (see Fig. 1)
1.6 Make sure tank valve is in "OFF" position (clockwise).
lOCKInG
KnOB
MOdel MH30T
Mr. Heater | Gas-Fired Infra-Red Portable Heater
reFleCTOr
HOse asseMBlY
reGulaTOr
KnOB
TIGHTen
Hand wHeel
POl nuT
lP CYlInder
COllar
MOunTInG BraCKeT
Figure 1
MOdel MH30Ts
3
1.7 Make sure regulator knob is in "OFF" position by turning knob
clockwise to off.
1.8 Carefully screw POL nut directly into bulk tank valve finger tight,
turning counterclockwise; then using hand wheel, tighten POL
into bulk tank valve.
1.9 Always connect the heater to bulk tank in the outdoors or in a
well ventilated area. neVer connect heater to bulk tank near
an open flame.
1.10 Use only LP-gas cylinders constructed for use with propane only
(HD-5) and marked in accordance with the specifications for
LP-gas cylinders of the U.S. Department of Transportation (DOT
Spec. 39).
1.11 Read complete manual before lighting heater.
Warning
Never touch heater while in operation to avoid injury.
Move heater by grasping the propane cylinder carefully.
Operating Instructions and Owner's Manual
sParKlITe IGnITer
saFeTY
sHuT OFF ValVe
TanK ValVe