Page 1
DO NOT use this device in areas where gasoline or other liquids having flammable vapors are stored or used. SAVE THESE INSTRUCTIONS Model: MH500LPT Model: MH400PT Propane Torch Model #MH500LPT & MH400PT...
Page 2
Always ignite flame safely without exposing body, clothing or anything combustible to ignited torch. MH500LPT - Always ignite using striker provided with torch. MH400PT - Ignite using a fireplace match or extended flame lighter.. DO NOT apply heat or flame to tank to check for leaks or to increase gas pressure.
Check for any dents or damage. The o-ring must be present. If damage is found or the o-ring is missing call Mr. Heater for the proper replacement parts. 2) Connect the excess shut-off valve end of the hose assembly to the shut-off valve of a LP gas tank and tighten counterclockwise.
- Slowly open supply tank shut-off valve and retest connection. Repeat if necessary - If leak cannot be stopped by tightening the stem packing nut a new valve assembly may be required. Contact Mr. Heater for the proper replacement parts.
If damage is found, contact Mr. Heater for the proper replacement parts. 2) Visually inspect LP gas tank(s) for dents, damage to collar, damage to shut-off valve or corroded foot ring.
ANSI Z49.1 “Safety in Welding and Cutting” NFPA 54 “National Fuel Gas Code” NFPA 58 “Standard for the Storage and Handling of Liquefied Petroleum Gases” CGA 2.29 “Hand Held Torches for Fuel Gasses” Mr. Heater | Propane Torch Operating Instructions and Owner’s Manual...
Page 7
CAUSE INJURY OR DEATH. REPLACEMENT PARTS ARE ONLY AVAILABLE DIRECT FROM THE FACTORY AND MUST BE INSTALLED BY A QUALIFIED SERVICE AGENCY. ANSI/UL 147-2009 CGA 2.29-1997 When it comes to quality hvac & refrigeration, Mr. Heater is the brand you can depend on.