Pella 350 Series Owner's Manual page 16

sliding Patio Doors Operation/Screens/Grilles/Blinds
s l i D i n g Pat i O D O O r s
OPe r at iO n
locking system
thumbturn lock
The thumbturn lock is located on the flat panel behind the door handle. to lock the
door, fully close the venting/sliding panel and turn the thumbturn to a horizontal
position. to unlock the door, turn the thumbturn to a vertical position.
s Cr e ens
to remove the screen door for storage, lift the screen and tilt the bottom portion away from the sliding
door while lifting the screen out of the sill frame track.
nOte: Use a putty knife to lift the rollers out of the bottom channel.
CaUtiOn: Use caution when children or pets are around open windows and patio doors.
screens are not designed to retain children or pets.
gr i lle s
aluminum grilles-between-the-glass
The aluminum grilles are permanently installed between panes of insulating glass, so they stay clean and never need to be removed.
bl inD s
blinds-between-the-glass
The aluminum blinds are permanently installed between panes of insulating glass, so they stay clean and never need to be removed.
blinds-between-the-glass operation
Move the operators up and down in a slow and steady motion. The operators are attached
to the operating mechanism with high-powered magnets. Moving the operators abruptly
could cause them to become disengaged from the magnet.
nOte: if a handle becomes disengaged from the operator and
remains attached to the track, slide the operator up and down until the
magnet reengages. slowly slide the handle all the way to the top of
the track to fully engage the handle with the operator.
if the blind does not completely lower on one side, using the tilt
operator, ensure the slats are in the open position, then raise and
lower the blind.
5.1
locked Unlocked