Fixed Glass Assembly - Quadra-Fire COLBAY-INS Owner's Manual

L. Fixed Glass Assembly
Removing Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Open lower access panel. Pull out and unhook the two
spring latches on the bottom of the appliance that secure
the door.
Rotate the door forward approximately 1-1/2 in. (38 mm).
Holding the ashlip, lift the door up off of the stationary
latches and away from the appliance.
Replacing Fixed Glass Assembly
• Door Frame with Glass Assembly Replacement
Use only Door Assembly replacement, as specifi ed in
Section 14 of this manual, available from your dealer,
if any glass becomes broken in the Columbia Bay
Insert.
Follow the previous instructions to install the door crown
and grille to the new Door Assembly.
STATIONARY LATCHES
SPRING LOADED LATCHES
Figure 12.23
Quadra-Fire • COLBAY-INS • 7002-109 Rev. P • 8/11 35