Voltage Conversion To 240V - Grizzly G1163 Owner's Manual

voltage Conversion to 240v

the voltage conversion MuSt be performed by
an electrician or qualified service personnel. to
perform the voltage conversion, install the cor-
rect plug and rewire the motor to the new voltage,
according to the provided wiring diagram. If the
diagram included on the motor conflicts with the
one on Page 24 in this manual, the motor may
have changed since the manual was printed. Use
the diagram provided inside the motor wiring junc-
tion box.
Items Needed
• phillips head Screwdriver #2 ..................... 1
• Electrical tape ............................ as Needed
• Wire Nut (16 aWG x 3) ............................... 1
• 6-15 plug .................................................... 1
To convert the Model G1163/G1163p to 240v:
1.
DiSCoNNECt MaChiNE FRoM poWER!
2.
open the motor junction box, then loosen the
120 Volt Motor
wire nuts indicated in figure 4.
loosen
these
Wire Nuts
figure 4. location of wire nuts to be loosened
on when converting voltage.
Model G1163/G1163P (Mfg. Since 9/12)
Qty
Start
Capacitor
200MFD
125VAC
Run
Capacitor
30MFD
250VAC
Wt
Ground
Start
Capacitor
200MFD
240 Volt Motor
125VAC
Run
Capacitor
30MFD
250VAC
Wt
Ground
3. use wire nuts to connect the wires as indicat-
ed in figure 5. twist all three wire nuts onto
their respective wires and wrap them with
electrical tape so they will not come loose.
Connect
Wires with
Nuts here
figure 5. Model G1163/G1163p rewired to
4. Close and secure the motor junction box.
5. Remove the 5-15 plug from the power cord
and install a 6-15 plug according to the manu-
facturer's instructions.
Paddle
Switch
120 VAC
5-15 Plug
Neutral
Hot
Ground
Paddle
Switch
240 VAC
6-15 Plug
(As Recommended)
Hot
G
240
VAC
Hot
Start
Capacitor
200MFD
240 Volt Motor
125VAC
Run
Capacitor
30MFD
250VAC
Wt
Ground
240v.
Ground
Paddle
Switch
240
6-15
(As Reco
Hot
240
VAC
Hot
Ground
-11-