Water Container; To Remove The Container - Hoover 9 kg Vision HD Instruction Book

40005241Eng.qxd 05/09/2007

Water Container

The water removed from the laundry during the
drying cycle is collected in a container at the
bottom of the dryer.
When the container is full the 'Réservoir Plein'
indicator on the control panel will light, and the
container MUST be emptied. However, we
recommend that the container is emptied after
each drying cycle.
NOTE: Very little water will collect during the
first few cycles of a new machine as an internal
reservoir is filled first.

To remove the container

1. Gently pull out the tray until it is completely
removed. Support the tray with both hands.
When it is full the water container will
weigh about 4kg.
2. Tilt the water container to empty the water
out through the rear hole. When empty
slide the water container back into position.
PUSH FIRMLY INTO PLACE.
NOTE: If you have the option of drainage near
the dryer it is possible to use the discharge kit to
provide a permanent drain for the water
collected by the dryer. This will remove the need
to empty the water tray. All the information for
assembly of the kit is contained in the kit
envelope.
11:31 Page 13
13