Hp Z620 Workstations - Intel Ahci Sata Controller Guidelines - HP Z220 SFF Maintenance And Service Manual

HP Z620 Workstations — Intel AHCI SATA controller guidelines
See HP Z620 Workstation system board components on page 26
board connectors.
NOTE: Port 0 is the default port for the boot drive (the default port can be changed manually in the
BIOS).
System board
connector
SATA 0
SATA 1
SATA 2
SATA 3
SATA 4
SATA 5
SCU 0
SCU 1
SCU 2
SCU 3
eSATA = external SATA (2 ports per cable assembly)
HDD = hard disk drive
ODD = optical disc drive
NOTE: If there are fewer than three hard drives in the configuration, the cables from HDD bays 1 and 2
are pre-plugged to the system board SATA ports.
NOTE:
Only the most common configurations are shown here.
98 Chapter 3 Component Replacement Information and Guidelines
Drive installation scenarios
1
SATA HDD 1 SATA HDD 1
SATA HDD 2 SATA HDD 2
ODD 1 ODD 1
SATA HDD 3 SATA HDD 3
SATA HDD 4 ODD 2
—
—
—
—
—
to determine the location of system
2 3
SATA HDD 1
SATA HDD 2
ODD 1
SATA HDD 3
eSATA (top)
— eSATA (bottom)
— —
— —
— —
— —